Garmin 160 Instrukcja Użytkownika

owner’s manualFishfi nder 160FF 160 updated covers.indd 08/07/00, 12:10 PM1

2Installation Mounting the TransducerProper transducer installation is key to getting the best performance from your new unit. If the tr

3InstallationMounting the Transducer In-hull InstallationThe 010-10224-00 transducer is designed to be mounted inside a fiberglass hull. The standard

4Installation Slide clamp band through slot in bracketClamp BandCable TiesWorm GearMounting the TransducerTrolling Motor InstallationIncl

5InstallationInstalling the Wiring HarnessWiring Harness InstallationThe Fishfinder 160 comes with a wiring harness that connects the unit to power an

6Installation Wiring Harness Installation (continued)If your boat does not have a fuse block, the unit can be wired directly to the batt

7InstallationInstalling the DisplayDisplay Installation (Surface Mount)The Fishfi nder 160 can be mounted to a fl at surface using the supplied Surface

8Installation Installing the DisplayDisplay Installation (Flush Mount)The Fishfi nder 160 can be mounted fl ush against a dash or electroni

9InstallationTesting the InstallationTesting the InstallationWhile it is possible to perform some checks with the boat trailered, to properly test the

10Unit Operation Keypad FunctionArrow KeysThe Arrow Keys are used to select items on the Adjustment Bar and Setup menu and to change fi el

11Unit OperationAt the top left of the display you will find the Adjustment Bar and a variety of user-selectable information including Depth, Battery

© 1999 GARMIN CorporationGARMIN International, Inc.1200 East 151st Street, Olathe, Kansas 66062, U.S.A.Tel. 913/397.8200 or 800/800.1020Fax 913/397.8

12Unit Operation The Adjustment BarUsing the Adjustment BarThe Adjustment Bar allows direct access to the settings most commonly changed

13Unit OperationThe Adjustment BarZoomThe Zoom Adjustment is used to quickly select a display zoom scale. To change the zoom scale:1. Highlight ‘Zoom

14Unit Operation GainThe Gain Adjustment allows the user to control the sensitivity of the unit’s receiver. This provides some flexibili

15Unit OperationSetup Menu/ChartSetup MenuThe Setup Menu contains the unit settings that should not require frequent change. The Setup Menu is divide

16Unit Operation Setup Menu/ChartWhiteline‘Whiteline’ controls how the unit displays information about the bottom type (hard or soft). W

17Unit OperationSetup Menu/ChartScaleThe depth ‘Scale’ is displayed vertically along the right side of the chart. The depth ‘Scale’ can be configure

18Unit Operation Setup Menu/ToolsTools The Tools tab contains the ‘Depth Line’, ‘Noise Reject’, ‘Flasher’, and ‘Simulator’ tools. The ‘De

19Unit OperationSetup Menu/ToolsRemember when setting the Noise Reject tool, the higher the noise rejection setting, the more likely the unit is to no

20Unit Operation Setup Menu/NumbersNumbersThe ‘NUM’ (Numbers) tab allows you to choose whether you would like to see normal or large numb

21Unit OperationSetup Menu/NumbersTemperatureThe Fishfinder 160 can display the water temperature when equipped with a temperature sensing transducer.

iIntroductionHelp us better support you by completing our on-line registration today! Have the serial number of your Fishfi nder 160 handy and connect

22Unit Operation Setup Menu/AlarmsAlarmsThe ‘Alarm’ tab allows you to activate and configure the four alarms available in the Fishfinder

23Unit OperationSetup Menu/AlarmsDeep WaterThe ‘Deep Water’ Alarm can be set to sound a warning at a depth determined by the user. Before the unit wi

24Unit Operation SystemThe ‘Sys’(System) tab contains the ‘Contrast’, ‘Beeper’, and ‘NMEA’ Output setups. To access the ‘System’ Setup M

25Unit OperationSetup Menu/CalibrationsCalibrationKeel OffsetThe ‘Keel Offset’ fi eld allows the user to offset the depth reading for a keel or for the

26Unit Operation Setup Menu/UnitsUnitsThe ‘Units’ tab contains settings for ‘Depth’, ‘Temperature’ and ‘Speed’. To access the ‘Units’ ta

27Unit OperationSetup Menu/MemoryMemoryThe ‘Memory’ tab contains the settings for unit memory, allows you to reset the unit to the factory setup and

28On the Water28On the Water112233Understanding SonarIf you are familiar with sonar, and can determine what is on the chart, this section may not be

29On the Water29On the WaterTransducer CoverageTransducer CoverageThe area covered by the transmitted sound waves is determined by the cone angle of t

30On the Water30On the WaterUnderstanding the ChartUnderstanding the ChartIt is important to understand that the unit does not display a 3-D repre-sen

31On the Water31On the WaterUnderstanding the ChartWhitelineThe Fishfi nder 160 can help you to determine if the bottom is hard or soft. When the sona

iiIntroductionGARMIN Corporation warrants this product to be free from defects in materials and manufacture for one year from the date of purchase. G

32On the Water32On the WaterUnderstanding the ChartThermoclinesOne of the unique features offered by GARMIN is See-Thru® technol-ogy. See-Thru® techn

33On the Water33On the WaterSimulator ModeSimulator ModeThe Fishfinder 160 comes with a built-in simulator mode that will allow the user to practice a

34On the Water34Appendix ASpecifi cationsPhysicalCase: Fully Gasketed, high-impact plastic alloyDisplay: 3.3” x 3.3” (8.3 x 5 cm) 160 H x 160 W pixels

35On the Water35Appendix BAlarm Messages and IconsThe Fishfinder 160 displays a message when an alarm is tripped. To clear the message press the ENTE

36On the Water36Appendix CFishfi nder 160 Portable Fishfinder 160 PortableThe Portable CaseThe Portable Case is designed for rugged use and provides s

37On the Water37Appendix CFishfi nder 160 Portable When storing the Suction Cup Transducer in the case, dry the trans-ducer and cable to avoid corrosi

38On the Water38Appendix DIndex AAccessories ...

39On the Water39Appendix DIndexIIn-hull Installation ... 3Ins

40On the Water40Appendix DSSoftware Version ... 27Specifi cat

FF 160 updated covers.indd 08/07/00, 12:10 PM3

iiiIntroductionPackaging and AccessoriesThe Fishfi nder 160 Standard Package contains the following items:• Fishfi nder 160• Protective Front Cover•

© 1999 - 2000 GARMIN CorporationGARMIN International, Inc.1200 East 151st Street, Olathe, Kansas 66062, U.S.A.GARMIN (Europe) Ltd.Unit 5, The Quadran

ivIntroductionTable of ContentsIntroduction... i-viCustomer Service ...

vIntroductionTable of ContentsAlarmsFish Alarm ...

viIntroductionThe Fishfi nder 160 is able to display a variety of useful information about the underwater environment. Below are a few things the unit

1InstallationSelecting a TransducerTransducersThe transducer acts as the eyes and ears of your new sonar. Proper transducer selection and installatio