Garmin SA01933LA_D Instrukcja Obsługi Pobierz pdf (Strona 28)

Instructions for Continued Airworthiness G600, GNS 530W, GNS 430W, 190-01080-05 Rev. 2

GMA 347, GTX 330D, GMX 200, WSI AV-200 Cessna 208/208B Page 28 of 29

5. Tin the center conductor, then solder the contact onto the center conductor, butting the contact up

against the cable insulator. Do not exceed specified solder temperatures in Table A-1.

6. Flair the outer shield braid by gently rotating the contact and dielectric, then finish to flare out,

taking care not disturbing the inner foil shield. Do not remove the inner foil shield from the

dielectric.

7. Insert the contact into the rear of the connector body. The inner shield goes inside of the

connector body and the braid shield goes outside, until the contact snaps into place. Slide the

crimp tube up over the braid and up against the connector body. Crimp using tooling specified in

Table A-1.

8. Install black adhesive heat shrink into place past crimp tube and up over connector body and heat

shrink into place.

9. Reattach the connector to the corresponding transponder antenna or transponder rack.

10. Perform function checks as specified in section 2.5.1.

A.2 DME Cable Connectors

Table A-2 lists required tooling to accomplish the termination.

Table A-2. DME Cable Tooling

Item

Description / Part No.

Hex Die Tooling

Military P/N = M22520/5-43

-or-

Daniels P/N = Y141

Tool Frame

M22520/5-01 (HX4)

Hex Size

A Hex

Solder Temp

700 – 750F

Termination Instructions (Ref Emteq Dwg ES-105-1):

1. Disconnect faulty connector from DME or DME antenna. Cut the connector off completely using

snips or diagonal cutters. Make every attempt to limit the amount of cable which is removed along

with the connector.

2. Slide on heat shrink label, black adhesive heat shrink, and crimp tube. Installer is responsible for

remaking cable labels. Use existing cable label as a reference.

3. Strip the cable insulation according to the following diagram:

1 2 ... 23 24 25 26 27 28 29

Brak uwag

Garmin SA01933LA_D Instrukcja Obsługi Strona 28