
Garmin G1000 Cockpit Reference Guide for the Cessna Corvalis/Corvalis TT
190-00567-05 Rev. A
Appendix
109
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
Loading the Active Navigation Database
The Navigation Database that is loaded to internal memory as the active database
will be used by the system.
NOTE: Loading the Navigation Database as the active database prior to its
effective date will result in the expiration date on the power-up screen and
the effective date on the AUX-System Status Page being displayed in yellow.
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1)
With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD1 or MFD) to be updated (label
of SD card facing left).
2)
Turn the system ON. A prompt is displayed in the upper left corner of the
display:
3)
Press the NO Softkey to proceed to loading the active database.
4)
A prompt similar to the following is displayed. Press the YES Softkey to update
the active navigation database.
5)
After the update completes, the display starts in normal mode.
6)
Turn the system OFF and remove the SD card from the top card slot.
7)
Repeat steps 1 through 6 for the other displays (PFD1 or MFD).
8)
Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
10)
Turn the small FMS Knob to select the System Status Page.
11)
Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB). Verify the
correct active navigation database cycle information is shown for each display.
Komentarze do niniejszej Instrukcji