GHP™ Reactor SmartPump Installation InstructionsImportant Safety Information WARNINGSee the Important Safety and Product Information guide in the prod
When you select , the rudder must turn so that the boat steers to the left, and when you select , the rudder must turn so that the boat steers to th
Performing the Autotune ProcedureBefore you can begin this procedure, you must have a large stretch of open water available.1Adjust the throttle so th
4Test the autopilot configuration.5Repeat steps 3–4 until the autopilot performance is satisfactory.Adjusting the Autopilot Gain Settings1Enable Deale
helm control, and the white wire (Tx/B) from the helm control must remain unconnected.ÀNMEA 2000network (provides power to the helm control)Á12 Vdc po
NMEA 2000 PGN InformationCCUType PGN DescriptionTransmit and receive059392 ISO acknowledgment059904 ISO request060928 ISO address claim126208 NMEA: Co
NOTE: Depending upon the configuration of the autopilot, certain settings may not appear.NOTE: On a powerboat, each time you change to the Speed Sourc
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. GHP™, GHC™, Reactor™, and Sh
• The area behind the mounting surface must allow room for the routing and connection of the cables.Helm Control Connection Considerations• The helm c
If the boat has an unbalanced cylinder steering system, you must configure the pump to work properly with the steering system.1Remove the check valves
Item Description Important ConsiderationsÇPump power cableThe pump must be connected to a 12 to 24 Vdc power source. To extend this cable, use the cor
ÅShut-off valvesÆHelmÇSteering cylinderDual-Helm without Power Assist LayoutÀReturn lineÁShadow DriveÂStarboard lineÃPort lineÄShut-off valvesÅPumpÆUp
your particular installation, you can begin mounting and connecting the components.Helm Control InstallationYou must Install the helm control by flush
• If the boat has a power-assist module, connect the return line T-connector to the pump fitting labeled with a T.8Install the Shadow Drive in the por
11If necessary, add fluid to the helm reservoir.12Repeat steps 3 through 11 for the starboard side.13Hold (port) on the helm control until steering
NOTE: The braided drain wire (bare) on the NMEA 2000 power cable must be connected to the same ground as the black wire on the NMEA 2000 power cable.3
Komentarze do niniejszej Instrukcji